Pacific Northwest CNC Show/ Swapmeet

[mlaws1172]

Just wondering if there would be any interest in a CNC show/swapmeet in the Nothwest.
I am located in Central Washington and can get a place to hold it if there is enough interest. There are two volunteers in our office who would put it togethor.

Any interest?

mike

[juzwuz]

I'd be interested if it was in the Puget Sound area. I'd bet you could get more people from Oregon up to Vancouver,BC if the event was near Seattle.

[mlaws1172]

No doubt you are right but wrong side of the state for me to setup anything.

Besides maybe you Westside guys might enjoy some sunshine and winery tours

mike

[WA Toolman]

<Raises hand> SW WA state here. Where would it be held?

[mlaws1172]

Zillah, Wa -about 20 miles from Yakima

mike

[tinman13]

Hi mike, That sounds cool.......I would be interested in attending.
Steve

[gpnjuice]

I am a newbie here, but I would be interested. (Yakima)

[mlaws1172]

Welcome
GPNJUICE , glad to see someone else from the valley. What is your interest?

Thanks Steve.

I have come up with a 24x24 router/engraver/plasma table. the frame is

made from one sheet of 18ga. It goes togethor fast. We could assemble one

(or more) and set it up at the get togethor. A hands on kind of thing?

When would be a good date for this?

mike

[hercules]

I would be there if you pulled it off

[mlaws1172]

Not looking like it is going to fly, but it was worth a try.
mike

[vasko]

All is good!

[automizer]

I just found this post today, I'm from Vancouver BC for a weekend event I would be interested, I think if you keep this idea up and maybe plan for a year from now you could have a pretty nice event set up