Lesson

[pinemartin]

Found a great site from dertsap...
If your a complete beginner. Learn about programming and what the fucntions do!! an g/codes.
www.routoutcnc.com

[dertsap]

not sure where you got that particular link this is the one i sent you earlier
http://www.majosoft.com/engraving/html/
good info and some neat software as well

if you do a few google searches you'll find a lot of good information that you will find helpfull

http://gcam.js.cx/index.php/Main_Page
free cadcam which may be helpfull

[pinemartin]

Sorry should of said that i found routerout having used another path shown by derstap

[jscpower]

I haven't posted because I just too busy with other endeavors. I own a small 3 axis mill from Harbor Freight, surplus steppers and power supply from other sources. I plan to use Gecko drives for the electronics and downloaded Mach2Mill. I have extensive electronics, some programming and a fair amount of mechanical experience. I'm confident that this going to be an interesting learning experience. Haven't started to play yet though. Probably this fall I will. I have quite an extensive range of tools including a drill press, lathe, grinders etc. This just another attempt to soothe my ADD.