Who is going??? - CNCzone.com-The Largest Machinist Community on the net!

CNCadmin · #1 03-14-2003, 01:48 PM

Who is going to the WESTECH Tool Show in the Los Angeles
Convention Center on March 24-27 ? Are their any shows like this on the east coast?

CNCadmin · #2 03-14-2003, 03:30 PM

Is there any in NJ area?

hardmill · #3 03-14-2003, 10:15 PM

i'll be there

CNCadmin · #4 03-18-2003, 03:39 PM

Hardmill did you get my pm?

hardmill · #5 03-18-2003, 10:43 PM

If your reffering to the flyers i'd be happy to.

JIMMY · #6 03-20-2003, 12:20 AM

I am going to WESTECH

Turbine · #7 03-24-2003, 10:35 PM

EASTEC is the the eastern version of the same. (Springfield Mass.)
Go to the SME site (after WESTEC blows over) for info. You would need to camp out coming from NJ. It would be worth it if you're into it. There's usually six very large buldings full. I go every year so I'm not easily impressed.

CNCadmin · #8 03-24-2003, 10:37 PM

Originally posted by Turbine
EASTEC is the the eastern version of the same. (Springfield Mass.)
Go to the SME site (after WESTEC blows over) for info. You would need to camp out coming from NJ. It would be worth it if you're into it. There's usually six very large buldings full. I go every year so I'm not easily impressed.

How many vendors would you say will be there?

hardmill · #9 03-24-2003, 10:59 PM

Hey turbine good to see you here

Turbine · #10 03-25-2003, 10:51 PM

CNCadmin,
The site is up.
700 exhibitors
www.sme.org/eastec.

JIMMY · #11 03-25-2003, 11:10 PM

I went today, 3/25/03. The show is full of alot of new products. I spent 7 hours there today.

CNCadmin · #12 03-31-2003, 03:16 PM

Originally posted by Turbine
CNCadmin,
The site is up.
700 exhibitors
www.sme.org/eastec.

http://www.sme.org/cgi-bin/get-event...7-008799--SME-

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)