- Toyoda FV1680 / WELE AA1680 automatically adjusting feed rates when using cutter comp
-
Registered
Toyoda FV1680 / WELE AA1680 automatically adjusting feed rates when using cutter comp
I am trying to figure out how to disable the automatic feed rate adjustment for this machine. We are using radius offset cutter comp in a lot of our programs, and we end up needing to double our feed rates because whenever we are doing an internal helical ramp the controller is automatically cutting the feed rate in half.
Does anyone know if/where this parameter is? I am having trouble finding anything in the manual. A PDF of the manual would be nice to so I can ctrl-f through it.
It's a Fanuc 0iMD controller if that helps.
Thanks
Similar Threads:
-
- Toyoda FV1680 / WELE AA1680 automatically adjusting feed rates when using cutter comp
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules