Tormach should show off videos like this

[LazyMan]

I will likely be purchasing my 1100 within a month and just came across this video and its making me excited.

http://www.youtube.com/watch?v=h2t0sDBzYmE&feature=relmfu]Hoggin' Aluminum with Tormach PCNC 1/2" Rougher - YouTube

[Steve Seebold]

That works great if you use a corn cobb end mill, but if you try to do that with a finisher your cutter will pull down.

[David Bord]

Lazyman,

Check this out: http://www.youtube.com/watch?v=Ft4n2rCWSG0]Testing the Tormach 17mm Center Cutting Insert Endmill - YouTube

David

[tikka308]

Hey - that's my video! Tormach did tweet about it, FWIW...

I will likely be purchasing my 1100 within a month and just came across this video and its making me excited.

[LazyMan]

Good stuff! Its going to be a massive step up from my "X3" conversion.