BobCad Cam post for Tormach PCNC - CNCzone.com-The Largest Machinist Community on the net!

brooklynmetal · #1 09-08-2007, 10:53 AM

Hello everyone,

I recently made the leap and purchased a Tormach PCNC mill.
I own a Bridgeport 2J and have a good deal of manual mill experiance.
The initial CAM software I was using was SprutCAM however I returned it
because the email tech support was not a realistic option.
Thankfully Tormach refunded my money, (then changed its return policy to no software returns) and I purchased BoBCad CAM V21.
I am using the Mach 3 controller and would like to know if there are any other
PCNC owners using BCC and if so are you using the BCC Mach 3 post?
If I upgrade to BCC 2007 is the post still Mach 3 or is it differant?

Best, Dave

tjones · #2 09-08-2007, 03:51 PM

There is someone that can help you over on the CADcAM trainer sight with the tormach related questions.

http://www.cadcamtrainer.com/forums/...splay.php?f=80

brooklynmetal · #3 09-08-2007, 07:42 PM

Thanks very much for the link, I will look it over asap.
Thanks

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TORMACH CNC PCNC 1100 only $6800.00 ???	twocik	Benchtop Machines	4	08-21-2007 03:26 PM
Tormach PCNC owners - can you post some sizes please	keen	Tormach PCNC	15	07-09-2007 11:05 PM
syil sx3 vs tormach pcnc 1100	ataxy	Benchtop Machines	20	03-16-2007 11:51 PM
Engraving on The Tormach PCNC	phil burman	Benchtop Machines	14	09-15-2006 09:45 PM
Any Interest in a Tormach PCNC Forum?	dkaustin	Suggestions for the CNCzone.com site.	5	07-29-2006 10:21 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)