| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Tormach PCNC Discuss Tormach PCNC machines here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-03-2007, 09:07 PM
| |||
| |||
| Post Ok, hope you guys can help me. I have a friend at a former job that has Gibbscam07 that is willing to do some programming for me. I was wondering if someone could post some NC code for the Tormach here. Something that uses all the G & M codes. I think I have the post made already but still can't get conformation until this Thursday. If I could get a little snippet of code from someone I might be able to compare it. (and if its not to much the 3d solid you used to generate it would be helpful I accept all major file types .dwg, dxf, 3dm, 3ds, lwo & iges)    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| I cannot post work offsets with Camworks I may need Post for Acromatic?? | acromastic | Post Processor Files | 0 | 06-21-2007 04:56 PM |
| Need post Delcam PowerMILL post for Hardinge VMC 600 II with Fanuc Series oi-MB | littlem | Post Processor Files | 0 | 10-26-2006 05:59 PM |
| | |
Linear Mode
