I am building a DIY toolchanger for my CNC and will use R8 collet and Tormachs tool-holders. But I would like to know the measurements on the holders in general but more specific the groove or slot(width, depth, chamfer and location) where the fork holds the toolholder in the ATC.
Is there someone that have a Tormach that can measure the groove in a holder for me?
The holder OD is 1.5". The groove is 0.090" high, located 0.21" below the reference face. The groove is 1.16" ID. The chamfer is roughly 45 degrees, with a height of roughly 0.07".
Of course, you could just spend the $20 to buy one...
Thanks a lot for the good answer!
I have bought a bunch of holders but they have been stuck in the Swedish customs for a week now and I dont know when I will receive them. With the shipping, VAT and customs-fee they cost almost double the price, but it is still a good price