Tormach 31858 - Digitizing Probe

[Zulor]

This item was purchased brand new from Tormach directly. It was tested for functionality when it came in but has otherwise never been used - So it's essentially brand new. Asking $1200 OBO. All reasonable offers will be considered.



Contains only the items in pictures. Items include:

(1) Digitizing Probe
(1) Probe Cable
(1) Probe Tip
(1) Case to hold the items (shown in picture)

This is a premium quality electronic digitizing probe that enables fast and accurate setup of jobs on the PCNC 1100 or PCNC 770 mill. Features sealed electronic contacts and red LED touch indicators. Uses a ruby sensor ball with replaceable breakaway ceramic stylus and is compatible with Renishaw M4 stylus family. TTS mounting geometry.

• The probe cable has a male 5 pin DIN connector. This connector interfaces with the auxiliary socket provided on the PCNC 1100 or 770 operators control panel.

Item will be shipped via USPS or FedEx, shipping insurance included and mandatory. Local Pickup available in Houston, TX as well.

Similar Threads:

• Tormach digitizing probe to find center of a small circle, but bigger than probe tip
• Tormach 31858 versus 32309 probes
• New Tormach Digitizing Probe Calibration Update
• Tormach digitizing probe off by 0.020". Where is Mach3 offset?
• digitizing probe