Are you on 2.0.0 or 2.0.1?
I probed a circular boss yesterday and it didn't crash to center. Sorry about that probe tip though. ouch.
I've got PP 2.0. I just tried probing using circular boss center. When it finished probing, it jogged to the center of the circle and broke my probe tip.
I was probing a pipe flange- thread OD area, not whole flange OD. See picture
Similar Threads:
- Tormach digitizing probe to find center of a small circle, but bigger than probe tip
- CMM Liquidation: Renishaw TesaStar Probe Head, Touch Probe, Motorized Indexable
- TP-100 Probe - Compare Performance Motion probe to IMService probe
- need to probe bore with boss in the middle
- Fixing a broke tool probe on tm-1?
Last edited by scott216; 01-23-2018 at 05:44 PM.
"You can't teach stuff in a school that you would learn in real life unless the real life people are in charge of the school." - Gene Sherman
Are you on 2.0.0 or 2.0.1?
I probed a circular boss yesterday and it didn't crash to center. Sorry about that probe tip though. ouch.
I tried it again today and it worked properly. That's good, but I wish I could reproduce the problem. Now I'm a bit wary and those probe tips are expensive!
"You can't teach stuff in a school that you would learn in real life unless the real life people are in charge of the school." - Gene Sherman