Path Pilot 2.0 Get Ready!!! Tormach has a page for it now!

[petenc]

There are rumors of a larger Tormach mill with linear bearings on the ways. Maybe this is it. Although I would think that would be named a PCNC2200 or something like that. PCNC50 doesn't seem to follow their current naming convention.

Sure hope we aren't gettin' excited over a 50lb machine lol. Maybe it would come with backpack straps.

[tmarks11]

Sure hope we aren't gettin' excited over a 50lb machine lol. Maybe it would come with backpack straps.

50#? That would be in 3D Printer territory... which seems unlikely, as that market is already swamped.

[Contract_Pilot]

the 50?? 8" X 4.8" X 5.125" ??? small machine.

[Contract_Pilot]

Just Dawned on me the A50 is the band Saw maybe the 50 is the bandsaw?

[kstrauss]

Which manual did you download? I tried all the latest manuals I could find online but no of them described the profile feature.
I've nevertheless been playing with it for a while and I was quite impressed with the first tests in imperial units (I haven't run the profile routine on the machine yet - maybe tomorrow). However, it took me a few attempts to get it running in metric because it carried some initial values from imperial and it wasn't too happy. Once you get the hang of it it's actually quite nice Just check over ALL the values.
Step

There is now a Tormach video on using the profile feature:

[tmarks11]

Just Dawned on me the A50 is the band Saw maybe the 50 is the bandsaw?

Could be. Seems like an unfortunate choice to have a PC run that thing. All you are selecting is cut width X ## of pieces. Seems like you could run that thing with an arduino. They managed to run the steppers for their surface grinder without resorting to PC control.