Here's some info:
Installing the ETS permanently on the PCNC – CADCAM-CNC
As far as I know, the Fusion PP post doesnt support Tool Measuring or Tool Break Control. But that doesnt mean you cant write your own and add it as with a manual NC op.
Hi Guys
If I want to mount my electronic tool setter permanently to the table of my PCNC1100, is there a way to setup path pilot and or Fusion and the Pathpilot Post to send the machine to a fixed known place to set the tool length?
Similar Threads:
Here's some info:
Installing the ETS permanently on the PCNC – CADCAM-CNC
As far as I know, the Fusion PP post doesnt support Tool Measuring or Tool Break Control. But that doesnt mean you cant write your own and add it as with a manual NC op.
Tormach PCNC 1100 Series 3 w/ Rapid Turn, Fusion 360