How to reconfigure Pathpilot from PCNC 440 to PCNC 770?

[MetalDawg]

I just received my new 770, and the 440 is going to a new home. The controller can not operate the 770 because the software is configured as a 440 controller. I updated the software thinking it might take me to a "decision" screen but it defaulted back to the original 440 selection. I searched the forums, but no luck on the subject.

Thanks!

Darryl

Similar Threads:

• Need Help!- PCNC 1100 vs PCNC 770 (Is the 1100 worth it)
• Tormach Controller or PathPilot Clone for PCNC 440
• Wtb pcnc 770
• Newbie- hello, and maybe something new for your PCNC's
• New PCNC 770

[MetalDawg]

Never mind... I just had a Duh moment. Reload disk....


Also found out you have to type into the MDI line ADMIN CONFIG and hit enter with the CD in the tray. It will not reload the software by just restarting the system with the CD first in the boot sequence.