Results 1 to 2 of 2

Thread: raw arc voltage?

  1. 11-30-2008, 06:27 PM #1
    texscrambler
    texscrambler is offline
    Registered
    Join Date
    Nov 2008
    Location
    us
    Posts
    1
    Downloads
    0
    Uploads
    0

    raw arc voltage?

    I have the Thermodynamics cutmaster A120 would anybody have an idea where I would tie into the raw arc voltage? I really appreciate the help

  3. 12-01-2008, 03:02 PM #2
    Mike@Torchmate
    Mike@Torchmate is offline
    Registered
    Join Date
    Jan 2007
    Location
    USA
    Posts
    316
    Downloads
    0
    Uploads
    0
    The Positive (+) lead goes to the connection on the main board inside the A120 labeled ELECTRODE1, and the Negative (-) lead goes to WORK1.
    Mike @ Torchmate.com | www.Torchmate.com
    Toll Free : (866) 571-1066 M-F 7:30am-4pm PST

« Torfchmate 2 Lunges | Signal generator need help »

Similar Threads

  1. what voltage?
    By haroldj in forum Stepper Motors and Drives
    Replies: 2
    Last Post: 03-04-2008, 07:10 AM
  2. Help..Stuck at relay ext dc voltage missing but dc voltage OK ?
    By Dirky in forum Bridgeport and Hardinge Mills
    Replies: 24
    Last Post: 11-27-2007, 08:33 AM
  3. DC Bus voltage on VF0??
    By DomB in forum Haas Mills
    Replies: 3
    Last Post: 03-11-2007, 03:14 PM
  4. LED Voltage
    By Mr.Chips in forum General Electronics Discussion
    Replies: 3
    Last Post: 02-03-2007, 02:10 PM
  5. Max voltage
    By tekno in forum PicStep Controllers
    Replies: 3
    Last Post: 04-02-2006, 06:49 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.