- Newbie- Torchmate 4x4
-
Registered
Torchmate 4x4
My torchmate 4x4 is not cutting to scale. Things that were created at 4 inches are cutting at 8 inches. Where are the settings located so I can reset them
Similar Threads:
-
-
Registered
Re: Torchmate 4x4
In the cutting software on the import scree there is a scale factor. Make sure it's not set to two instead of one.
Sent from my SM-G900V using Tapatalk
- Newbie- Torchmate 4x4
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules