- Torchmate 2 table with thermal dynamics A120 cutter
-
Registered
Torchmate 2 table with thermal dynamics A120 cutter
Is anyone else here running this setup?
I'm wondering what your specs are for cutting 3/16 and 1/4. And I'd take input on thicker but I haven't tried thicker yet
I seem to be getting a pretty good cut but there's a lot of slag hanging off the bottom.
Thanks!
Dave
Similar Threads:
-
- Torchmate 2 table with thermal dynamics A120 cutter
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules