- Secondary gantry system...
-
Registered
Secondary gantry system...
I'm just curious if any one had built a secondary gantry for, say a Torchmate 2x2. Although it still limits the total cut to 2x2, if one built a 4x4, or 4x8 water table and a secondary gantry system to manually move the 2x2 Torchmate into 4 different quadrants, at least one could use a half or full sheet of material. Bonus would be a water table with lots of room for manual cutting as well..... Any thoughts?
Similar Threads:
-
-
Registered
Re: Secondary gantry system...
I think it would be much easier to rebuild the table to be larger than to make a gantry to move it around.
- Secondary gantry system...
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules