Now Ive been through you tube and searched high and low on the net, really need someone that has one or has used one
The attachment has a dial at the back that goes from 1-18 and then again 1-18, the front behind the chuck has an eccentric cam that a couple of pins run on, if its a 2 flute item you put two pins in a threee flute then 3 pins etc, managed to work that out.
But I cannot work out how to get it to sharpen the drills properly. If I lock it in position 1 and set the flutes of the drill horizontal and then rotate the unit, the relief is actually grouind higher than the cutting egde, if I mount the flute edge vertical and repeat then I get a very flat profile. If I raise the incline of the drill jig then the front reliefs well but I get more of a mushroom shape to the drill bit,
Absolutley frustrating me. Does anyone have one or has anyone used one