Thunder Laser Y axis stopping mid job Diagnostic codes anyone?


Results 1 to 3 of 3

Thread: Thunder Laser Y axis stopping mid job Diagnostic codes anyone?

  1. #1
    Registered
    Join Date
    Mar 2015
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Thunder Laser Y axis stopping mid job Diagnostic codes anyone?

    As the title says. The stepper driver has two lights. The one on the left stays green, the one on the right blinks red 4 times, pauses 4 times,,,,and so on. Anyone abel to tell what the diagnostic code is for the 4 blinks?

    Thanks in advance.

    Similar Threads:


  2. #2
    Member BenM2's Avatar
    Join Date
    May 2014
    Location
    Tallahassee
    Posts
    29
    Downloads
    0
    Uploads
    0

    Default Re: Thunder Laser Y axis stopping mid job Diagnostic codes anyone?

    Not sure if Thunder Laser support reached out yet. The red light flashing just shows something's in error obviously. Im not
    sure of Thunders' drivers, but if you swap the drive and motor you see which is faulty.



  3. #3
    Registered
    Join Date
    Mar 2015
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default

    Quote Originally Posted by BenM2 View Post
    Not sure if Thunder Laser support reached out yet. The red light flashing just shows something's in error obviously. Im not
    sure of Thunders' drivers, but if you swap the drive and motor you see which is faulty.
    So this ended up being a y axis replacement. I do wonder why the y axis is an issue. They have a page specifically dedicated to replacing it...



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Thunder Laser Y axis stopping mid job Diagnostic codes anyone?

Thunder Laser Y axis stopping mid job Diagnostic codes anyone?