Results 1 to 3 of 3

Thread: DaVinci

  1. #1
    Registered
    Join Date
    Sep 2007
    Location
    United States
    Posts
    42
    Downloads
    0
    Uploads
    0

    DaVinci

    I recently acquired a used Techno Isel at an auction and after updating the software and OS to XP I have it up and running. I was filling out the check to my insurance company and it occurred to me that I needed to add that to the properties. What is such a machine worth?
    Scoob


  2. #2
    Registered Pplug's Avatar
    Join Date
    Jan 2007
    Location
    USA
    Posts
    629
    Downloads
    0
    Uploads
    0
    A couple grand used and abused.

    7500 from techno
    [url]Http://www.glenspeymillworks.com[/url] *Techno LC4896 - 2.2Kw Water Cooled Spindle | *Moving Table Mill from an Omis 3 CMM, 500Lb granite base, Hitachi router, Mach3


  3. #3
    Registered
    Join Date
    Mar 2008
    Location
    US
    Posts
    91
    Downloads
    0
    Uploads
    0
    Quote Originally Posted by Scooby Doo View Post
    I recently acquired a used Techno Isel at an auction and after updating the software and OS to XP I have it up and running. I was filling out the check to my insurance company and it occurred to me that I needed to add that to the properties. What is such a machine worth?
    It depends on condition and operating ranges (distances), and the electronics used. I doubt you could get more than $5K for an ISA bus based system, but the newer models depreciate slower.
    Joe Jared - OsiruSoft Research and Engineering - http://www.oretek.com


Similar Threads

  1. Davinci stepper with Galaad or Kay? Anybody?
    By Pplug in forum Techno CNC
    Replies: 0
    Last Post: 09-15-2010, 12:00 PM
  2. DaVinci
    By Scooby Doo in forum Techno CNC
    Replies: 7
    Last Post: 08-31-2010, 10:07 PM
  3. Need Help!- ISEL Techno G-Code DaVinci Education Mill
    By iflymyhelishigh in forum Commercial CNC Wood Routers
    Replies: 6
    Last Post: 08-30-2010, 05:17 PM
  4. Techno-Isel Davinci upgrade help
    By Ferny in forum General Electronics Discussion
    Replies: 2
    Last Post: 10-30-2008, 09:27 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.