Over travel limit Z question on a HD

[Pstocky]

Everything has been running ok....Changed some tooling and re zeroed the z at the spoil board .... Now when I start the program I get an error NC 118 Negative software overtravel limit Z message and it doesn't move .....Any one have any idea where to start looking for the problem

Thanks, Paul

Similar Threads:

• How far before the end of travel should I trigger the limit switch
• Override travel to get off limit switch...
• homing limit switch travel
• Delta 20 travel limit override
• How close to the end of your travel do you have your limit switches?

[Montabelli]

I don't know any thing about your controller, but I would check to see if there is a reset limits , or reset soft limits switch in the controller files somewhere