| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Teachers Hang out Discuss and share your ideas here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-19-2007, 01:46 PM
| |||
| |||
| Techno cnc Lathe Hi all. Our school just purchased a new techno CNC Lathe. After using it enough to become familliar with it's capabilities I am rather dissapointed with the techno control software. It only supports IN/MIN & RPM and is rather limited in the number of standard codes it recognizes. Also it is difficult to adjust mid program to get accurate diameters. I was wondering if Mach 3 would run this lathe and if so how do I go about changing over? The Techno runs off a special card in the pc with a cable similar to a printer cable but with 50 pins. I currently use Mach 3 mill on a Tormach PCNC1100 in my classroom. I think the consistency of having both machines running Mach controllers would be very helpful to both students and myself. I am a CNC rookie and would greatly appreciate any advise. Thanks, Dave    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Techno vs K2 | big_mak | Commercial CNC Wood Routers | 12 | 09-09-2007 05:20 PM |
| Techno Isel | wood_donkey | Commercial CNC Wood Routers | 2 | 04-19-2007 07:13 PM |
| Master cam to Techno | cadfish | General CNC (Mill and Lathe) Control Software (NC) | 1 | 03-06-2006 03:47 PM |
| Techno table needs it all! | 1bordeaux | DIY-CNC Router Table Machines | 0 | 05-23-2005 12:16 PM |
| anyone know of the Techno routers? | tekno | General Metal Working Machines | 2 | 06-08-2004 11:36 PM |
| | |
Linear Mode
