My Taig Setup And Ready To Go!

[WOODKNACK]

Well I have finished all the wires and everything is lubed and greesed. The machine is ready to go! I have engraved a few names with it so far. I am very impressed with it. nice little rig!

[ToyMaker]

Yo! way to go WoodKnack, you old motor-spinner, you.

robotic regards,

Tom

[CNCadmin]

Nice set-up!

[anoah]

To sweet! I'm jealous!!

[Klox]

Looks very, very good!!!

Klox

[CNCadmin]

What are the boxes under the stepper motors?

[balsaman]

Looks great. Are you sure that's yours? Looks like a pic from a web page or something. Too clean to be a real shop...



Eric

[WOODKNACK]

Those boxes I got at Radio Shack. They are just small project boxes. I drilled a hole on the bottom of the box and put the stepper motor wires thru the hole. then doubleside tape to the stepper I then have another hole on the other end for the wire that comes from my controller. I wire capped on all the wires and screwed the cover to the box on. Takes the strain off the wires and looks very neat I think!
Nothing looks worse then seeing wire just hanging! I like to do a neat job. While I was waiting for my mill to arrrive I repainted my bench. Thats why it looks so clean.

[Rekd]

Wow. Very nice job.



'Rekd

[WOODKNACK]

Here is a timing wheel gear for a clock I cut out on my Taig mill.
MY GOOD FRIEND STEVE sent me the gcodes for it. Thanks Steve. So far I am very impressed with the whole mill!! Picture is kind of blurry. Sorry..

[Klox]

Woodknack,
I had to change my display card, your image looks better now! (just kidding!)

Looks like your machine cuts very well, the shape of the gear teeth is out of the ordinary. Well done!
It's the first time I see teeth like this.
I think i must send all my gearcutting jobs to you.....LOL

Klox

[balsaman]

What material is that cut from?

Eric