Taig MicroMill 2000 config

[hamerskib]

Good day everybody
I have a Taig NC mill I bought some years ago and didn't use it.
It has MicroMill 2000 controller and was send with 2003 software version on a diskette.
Looks like Mach 3 now is the answer. Who could recommend me the exact configuration of the Mach 3 for this machine ? Is there a Youtube video or list of parameters with which to start ?
Is there any better solution ?
I want to start quickly. Where to buy Mach 3 ?
I have older version of Bobcad. Is it a good solution for CAM software? What about postprocessor? Is generic good for Taig ?

Thanks in advance
B. Hamerski
Montreal

[Jeff-Birt]

Can you send me an email to birt_j 'at' soigeneris 'dot' com ? I'll send you the profile for the Taig MM2000.

[lsces]

Mach-in-a-box Gallery - Model Engineers Digital Workshop

But I need to start padding out some of the information ...