Starting in the middle of a line with pathfinder - CNCzone.com-The Largest Machinist Community on the net!

10-02-2003, 07:26 AM

tahlinc

Join Date: May 2003

Location: Tucson, AZ USA

Posts: 64

Starting in the middle of a line with pathfinder

Pathfinder:

I like using the pathfinder tool because I can draw a rectangle then start a path in the middle of a segment by picking and showing direction of travel.

Also pathfinder makes it easy to navigate through a maze of conneted lines where there are choices of which direction to take.

Pathfinder converts circles to two semi-circular polylines by selecting the desired quadrant then dragging to show direction.

__________________
Jim Short
www.tahlinc.com

« Previous Thread | Next Thread »

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
single line fonts?	balsaman	General CAM Discussion	12	02-18-2006 12:51 PM
Single Line Font?	squarewave	Carken Products (Deskam, DeskCNC etc)	9	11-29-2004 07:03 PM
Finally starting on router project	ehiebert	DIY-CNC Router Table Machines	9	04-10-2004 08:07 PM
Tool tables	Nimrod	Mastercam	4	11-24-2003 03:31 PM
Line command	CNCadmin	General CAM Discussion	4	06-26-2003 03:42 PM

All times are GMT -5. The time now is 08:49 AM.