SX3 spindle speed controller (CNC Mode) - Page 2 - CNCzone.com-The Largest Machinist Community on the net!

iGG1e · #13 10-31-2008, 09:35 AM

Originally Posted by smallblock

Its been said before, but you should just dump all the Chinese electronics and start fresh. Anyone can deal with the mechanical issues of Chinese machines, but electronics problems will turn your hair gray.

The only trouble with that is they won't refund for the crap I send back to them. So we end up paying double anyway. Only a sucker pays twice? Guess I'm feeling like one now.

I'm going to feel guilty adding more to our landfill sites when I dump all of this stuff...probably full of toxins to cap it all off.

neilw20 · #14 10-31-2008, 09:40 AM

iGG1e.

Start a museum !

ataxy · #15 10-31-2008, 11:32 AM

Originally Posted by neilw20

Google East Crystal
look down the list
http://www.ecec.com.cn/english/
Good luck..

thx! as you said not much there

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
What is - Torque Mode? Position Mode? Speed/Velocity Mode?	sunmix	Servo Motors and Drives	25	10-26-2008 03:53 AM
Speed mode Commands	Andre' B	G-REX	0	11-15-2007 07:39 AM
Phase mode without controller	Alex101	TurboCNC	1	06-12-2007 05:53 AM
Haas Graphics Mode - changing display speed?	pdoherty	Haas Mills	15	04-09-2007 08:57 PM
Designing Spindle Speed Controller - Need Digispeed Specs	abasir	General Electronics Discussion	2	09-18-2005 01:28 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)