Connecting Auto Z Zero in X4+?

[john_t_h]

Looking at Mach3 10,11,12,13 & 15 are all used.

[Greolt]

Well sounds like you are out of luck. You have struck one of the frustrating limitations of the LPT.

Unless you can do without one of those items using an input. Like putting two limit inputs onto one pin.

Or go for a second LPT but that is more than a zero input is worth. To me at least.

Lots of other methods to finding zero on a work piece.

Greg

[PEU]

Originally Posted by Martin Long Peu, Have you installed this on a X4+ yet? Martin

We ran out of X4+'s, shipment is on the sea as I write this, will try it for sure when they arrive.

But it makes no difference, you still need an extra parallel port since the one used for the X4+ has no inputs left.
My advise is buy a second parallel port, sooner or later you will use it


Pablo