| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Syil Products Discuss Syil milling machines and conversion kits here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-13-2007, 04:43 PM
| ||||
| ||||
I have a some questions regarding the 4th axis configuration: - what is the standard for setting Zero in this axis? in one of the extremes of the screw or in the middle? - how do you reference this axis at startup? - the 4th axis is supposed to go around 360 or a little more? (or a little less?) Using my "eyemeter" it seems its some degrees short of 360º I machined a wood piece and made a small video (will upload in next post) but I didn't finished the piece because of these doubts. Thanks in advance  Last edited by PEU; 12-13-2007 at 07:11 PM.  |
|
#2
12-13-2007, 05:19 PM
| ||||
| ||||
| |
|
#3
12-14-2007, 12:20 PM
| ||||
| ||||
| Zero of a A is usually your Z axis 0 plane, or 0 degrees. Their is no referance on the Z. The A can go around any number of degrees you specify. 720, 1023, 20, etc. One full revolution is 360 degrees.
__________________ Direction, Commitment, Follow Through |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question About 4th Axis Configuration | Khalid | DIY-CNC Router Table Machines | 4 | 02-27-2009 11:52 AM |
| best bearings configuration for z axis for manual wood joint maker | endgrainguy | DIY-CNC Router Table Machines | 1 | 08-19-2007 08:10 PM |
| Axis configuration, please help. | alexccmeister | General Metalwork Discussion | 2 | 06-25-2007 05:38 AM |
| Configuration Of Output Pins In Parallel Port FOR 4 AXIS | Khalid | Open Source Controller Boards | 2 | 05-20-2007 01:55 AM |
| Need help with axis configuration | jetijs | TurboCNC | 2 | 08-24-2006 05:06 AM |
| | |
HELP: 4th Axis configuration (video posted) 
Linear Mode
