SX3 spindle control retrofit?

[Greolt]

I have a SX3 with a Syil conversion kit. It is from before the spindle control was implemented by Syil.

Can this control board be fitted to older SX3s?

Do they still have the same Sieg motor power control boards?

Or have they gone through upgrades in the last 12 months?

Below is a pic taken from the Syil America SX3 manual of Syil's spindle control board.

Greg

.

[syil]

could you sent me your mianboard pic,then we can konw the edition,we have 2 upgrade spindle G board,but if your machine very old,i think our kits can not fit on your machines.
so,frist sent me your mainboard pic or number to support@syil.com.cn

Your sincerely~
xushuo

[Greolt]

Thank you for your post Xushuo.

Which board do you mean?

The one mounted on the back of the column? Or The one behind the stop start buttons on the front?

Greg

[syil]

yes,the back of machine,big one,also we need a face board pic too,then we can konw what date of those electronic present.

xushuo

[Greolt]

Xushuo

Here are some pics of the control boards.

The front panel one has a plastic shield on it. That is my method of protection against the DRO shorting it out.

I can of course remove this for a better photo. But you can probably identify it without me doing so.

Greg

[syil]

you can see,i post 2 edition mainboard,and one of them similar than your pic,i think it is same,but we need konw your mainboard time,mean if before 2006,you buy machine at 2005,i think our spindle g board can not fit.

please provide more info of your mainboard,date,or pic of serise number.

[Greolt]

The pic of the board that you posted has this label, (the one in the machine)

FC1000WJYA(6.1)


The one in my machine has this label,

FC1000JY(3.0)
050504

Greg

[syil]

i can say it is 2005 old board.but..we may have a try,please sent your address to us support@syil.com.cn
i will sent a g spindle board to you,if you can use it pay us, if can not fit please sent to Syil australia.ok?

Your sincerely~
xushuo

[Greolt]

Thank you Xushuo.

I have sent you am email.

Greg

[Greolt]

Xushuo.

I sent you am email on the 27th and have had no response.

Did you get it?

Greg

[syil]

No i did not get emails,please sent to me by your address,we will arrange one G board for you to test.
xushuo

[Greolt]

OK Xushuo. I have sent it again.

Greg