![]() | |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Syil Products Discuss Syil milling machines and conversion kits here! |
| This forum is sponsored by: |
![]() |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
| ||||
| ||||
I get the occational question about pendants. Here's a pendant that costs less than $20. What I use, and it works wonderfully: USB 10 key pad (Staples $9.99) USB 6' Extension (Staples $6.99) You can get these units for as little as $5. Mach allows you to assign ANY key to just about an function you can imagine. E-Stop, Jogging, Feed and speed, etc. Plug it in and go. No additional software is needed.
__________________ Direction, Commitment, Follow Through |
|
#6
| ||||
| ||||
| Use "OEM Codes" in MACH to make this work, by the way. You can find them in the Mach Discussion Forum link on the MACH site. I am using a Logitech game controller (USB) for the same purpose. It has two joysticks but lacks enough buttons for all functions. It's another option and it was pretty cheap - around $14 at Wal-Mart if I recall. Scott
__________________ Consistency is a good thing....unless you're consistently an idiot. |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cheap Pendant | MarkWink | General Electronics Discussion | 0 | 07-02-2007 08:02 PM |
| NUM PAD Pendant? | bigz1 | DIY-CNC Router Table Machines | 2 | 05-15-2007 09:32 PM |
| MPG pendant | troy676zsj | Fadal | 0 | 07-30-2006 09:15 PM |
| Pendant | georgebarr | DIY-CNC Router Table Machines | 1 | 04-04-2004 09:59 PM |
| Cheap USB "Pendant" | vacpress | CNCzone Club House | 3 | 03-18-2004 02:06 PM |