| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Syil Products Discuss Syil milling machines and conversion kits here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
10-23-2007, 09:46 PM
| |||
| |||
So i had an x axis stop working It has a yellow light flashing on the middle of the driver board. I swapped it with my a axis and it works fine so i know the board is the problem. The question is what does the yellow light mean? Is there a way to reset it?
__________________ I don't give a damn if you don't like me, cause i don't like you cause you are not like me.  |
|
#2
10-26-2007, 02:16 AM
| ||||
| ||||
| Yellow is a overheating condition warning. They are self re-setting, but can indicate an internal failure.
__________________ Direction, Commitment, Follow Through |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Having a CRT failure on a ulti 2 KM-3 | godspeedbear | HURCO | 2 | 08-27-2007 05:57 PM |
| Unspecified failure message | Chrisjh | Syil Products | 14 | 07-04-2007 07:57 AM |
| Component failure | len | General Electronics Discussion | 24 | 12-10-2005 10:04 AM |
| Spindle failure | mechanicer | DIY-CNC Router Table Machines | 9 | 10-31-2005 05:11 PM |
| Bearing Failure | Mr.Chips | DIY-CNC Router Table Machines | 5 | 11-15-2003 10:03 AM |
| | |
Linear Mode
