| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Syil Products Discuss Syil milling machines and conversion kits here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-04-2007, 12:52 PM
| |||
| |||
As I mentioned before, the Syil UK support sent me a replacement very quick. However, this new spindle driver board does not look the same as the one in my machine, and in fact, they are not compatible. On the new driver, the control interface connector reads, Pin1 VCC GND 0 1 D SR R S 5V 5VG although there is nothing on the old driver board, you can find the connector pinout on the control board. The control board is “SPINDLE CONTROL PCB Rev 1.2”. The connections are, Pin1 S1 Fin F/R P1 P2 CE E6V EGND 5V GND Are the signals on the old driver and the new one interchangable? if so, how to cross connect them? Last edited by david_geng; 09-04-2007 at 01:40 PM.  |
|
#2
09-04-2007, 04:52 PM
| |||
| |||
| I afraid you need a new Spindle control pcb rev 1.4. |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Part Off And Continue | TURNING MAD | G-Code Programing | 3 | 12-04-2006 06:45 PM |
| Picstep problems continue | randyf1965 | PicStep Controllers | 11 | 07-12-2005 01:24 AM |
| Picstep problems continue | randyf1965 | PicStep Controllers | 0 | 05-28-2005 04:04 PM |
| The headaches continue | nervis1 | Fadal | 24 | 02-02-2005 07:57 AM |
| | |
Linear Mode
