| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Syil Products Discuss Syil milling machines and conversion kits here! |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
06-19-2007, 06:11 AM
| |||
| |||
Hi to all, I have converted a SIEG X2 mill to cnc based on Syil's X2 3axis cnc kit and Mach3. Everything worked fine until now that I can only jog Y axis and only in one direction. All input parallel port signals are ignored by Mach3. i.e. when pressing the EStop in syil's controller box, Mach3 does not get the signal as it used to. Seems that Syil PC interface failed somehow. Any ideas on which part is the hardware failure from? I have the simple interface, no spindle control (CNC-P4A, Rev:1.1). My multimeter measurements: Syil's Power supply outputs 48V DC, pc interface gets 48V DC, stepsdown & regulates to 12V DC (L4971) and 5V DC (LM7805). Thanks in advance  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with syil x3 cnc control... | scyan | Syil Products | 3 | 03-29-2007 11:11 AM |
| Syil Controller Question | mayhugh1 | Syil Products | 1 | 02-06-2007 01:39 PM |
| Super X3 spindle controller (by Syil) | ints99 | Syil Products | 6 | 12-10-2006 04:35 AM |
| Controller / interface | Esses | General Electronics Discussion | 0 | 11-01-2005 08:48 PM |
| i've a problem in my picstep v.4 & 4 Axis PC interface ! please help me :) | Seventeen | PicStep Controllers | 14 | 07-31-2005 07:49 AM |
| | |
Syil X2 cnc controller or PC interface problem 
Linear Mode
