Powering 1992 Citizen L-16



Results 1 to 3 of 3

Thread: Powering 1992 Citizen L-16

  1. #1
    Registered
    Join Date
    May 2010
    Location
    us
    Posts
    54
    Downloads
    0
    Uploads
    0

    Default Powering 1992 Citizen L-16

    I just got this lathe and am unsure what to purchase to power the required 200v 3 phase. I have a rpc that supplied 230 volt 3 phase. Do I need to purchase 3 buck/boost transformers to drop each leg from 230 to 200? Thanks, Chris.

    Similar Threads:


  2. #2
    Registered
    Join Date
    May 2010
    Location
    us
    Posts
    54
    Downloads
    0
    Uploads
    0

    Default Re: Powering 1992 Citizen L-16

    Ok, so I need 2 240/120 16/32 1kv buck boost transformers, They get installed between the 220 single phase panel and the rpc.



  3. #3
    Registered
    Join Date
    May 2010
    Location
    us
    Posts
    54
    Downloads
    0
    Uploads
    0

    Default Re: Powering 1992 Citizen L-16

    Correction to my earlier post. I will be wiring lathe in an open delta configuration after the rpc.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Powering 1992 Citizen L-16

Powering 1992 Citizen L-16