Newbie Surfcam Truemill 1.250 em feed and speed - CNCzone.com-The Largest Machinist Community on the net!

blbettis · #1 02-11-2010, 09:44 PM

I am trying to use surfcam truemill to machine a 3.625 deep pocket
can anyone help me with the proper depth of cut i should take along with stepover,feed rates etc..

I will be using a 3 flute high speed steel 1.250 diameter em .190 rad

machining center is an okuma 852v 120 in 50 taper 10,000 rpm max

Its my first time to use truemill so any advice would be helpful

CNCRim · #2 02-11-2010, 11:03 PM

since don't know the material you are cutting, so I recomment 50% stepover of the tool dia and feed .005/.006 per tooth.

blbettis · #3 02-12-2010, 06:43 PM

aluminum

blbettis · #4 02-15-2010, 09:26 PM

results from testing

1.250 3 flute hss em .190 r 2.0 loc

rpm= 2426 ipm=50. doc=2.0 engagement angle 60degrees

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
TRUEMILL IMCO POWER FEED ENDMILL	bala955	Surfcam	17	06-29-2009 07:06 PM
Speed & Feed	kal_pesh	Mastercam	4	02-23-2008 01:19 PM
Speed & Feed	kal_pesh	General CAM Discussion	1	02-20-2008 10:15 PM
RPM/Feed Speed 4 Ali?	bigz1	Engraving Machines	0	05-20-2007 05:14 PM
speed and feed again	fourperf	Fadal	13	01-25-2007 03:53 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)