Do surfcam has post for Mach3?

[jinu117]

Basically, I have Syil X3 and using bobcad/cam.... but thing honestly has very poor way of making tool path from what I saw so far unless I micromanage each part of work... and was thinking about way to optimize toolpath on something I will only make few parts at a time but takes quite some time to run through (few hours often).
I think surfcam might do the trick... TIA

[sinderal]

Just post a NC file you want (maybe Tool Change Sequence, Start Sequence and End Sequence and other special ) at here, and your scprt file. I think you will get the post which someone will write for you.