Post Processor

**scubanick** · 10-27-2006, 11:10 AM

Does Anyone Have A Post Processor For An Okuma Lathe
With An Osp 5020l Control For Surfcam

**sang sys** · 11-16-2006, 09:03 PM

Yes, i got post for it
it work very good

**sang sys** · 11-16-2006, 09:05 PM

Does anyone have post for Surfcam velocity Agie wire edm?

**tnik** · 11-17-2006, 09:34 AM

agie 2axis post..

**scubanick** · 11-17-2006, 11:16 AM

would you be interersted in sending in to me
or attaching it here

**tnik** · 11-18-2006, 07:18 AM

it is attached here..
AGIE.zip is in my post above.

**scubanick** · 11-18-2006, 07:42 AM

sorry about that i was talking to sang sys about the okuma post

**sang sys** · 12-04-2006, 07:47 PM

Originally Posted by scubanick

sorry about that i was talking to sang sys about the okuma post

Sorry, for the delay

Here are smartcam post for okuma act35 lath

if you any questions email me i will anwere if i can.

**sang sys** · 12-04-2006, 07:53 PM

Post for ACT35

It work very good.

Question email me.

**Tommy** · 07-20-2007, 12:40 PM

Does anyone have the Post Processor for Agie CNC 100 that works in BoBcad 16.1 Wire.

**tnik** · 07-20-2007, 02:41 PM

Bobcad will create the post for you, just contact them..

**Tommy** · 07-20-2007, 06:31 PM

Thanks for the reply, however Bobcad told me today I would have to upgrade they no longer support V16.1 Wire.

Thread: Post Processor