| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Surfcam Discuss Surfcam software here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-02-2006, 01:45 PM
| |||
| |||
 SDNC help im setting up a topper tmv400 fanuc 0-m controller and i keep getting errors on controller 085 087 001 been changing parameters to meet with the same settings as the com 1 port still no luck anyone with any suggestions would be great    |
|
#2
02-02-2006, 02:52 PM
| |||
| |||
| If the settings are correct in you parity, baud rate, etc: Nine times out of ten your cable needs to be worked on. The pins used are different for every machine, and sometimes different for the same controller. If you have a manual search for a diagram of the correct wire/pin relations. Good luck Chris |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
| | |
Linear Mode
