Surfaces

[moldcore]

Ok smarty pants, where is the undo button for joining surfaces? What version are you using? I’m using the latest build available and there is no undo button on my screen. If Surfcam has a bad name, it’s because of a lack of effort on their part, not ours.

BTW, you’re responding to a one year old post. However, the problem still exists.

A Surfcam user for 11 years.

[championp]

I want to know where the undo button is

[lagrandebug]

Now here we go there is no actual undo button. What you use is the delete button. Say you go and two surfaces and they kind of bow and go crazy. What you do is go and delete the surface then go up and hit undelete last, it will bring back that surface. Then hit undelete button again and again if there were two surfaces to begin with. Then go in after you hit it three times or however many times you did and delete the surface with the bad results. If you did it right you will then be left with the surfaces in the state they were in before you tried to join them. Then you can try again That works on most things like lines splines pretty much anything i have tried i get back by useing the undelete button. So there you go boys. let me know if it works.

[championp]

"Let me know if you want to know where the UNDO BUTTON is."

Look around this forum a little, most of us already knew that. In fact, look at the post right above your first post in this topic.

Thanks for being cocky about it though, we are all impressed.

[camaru]

There is sorta of an undo when joining surfaces or even editing tangency fails. Try undelete last the surfaces or splines prior to join or edit tangency will come back, if you use this edit the color of the messed up surfaces so you can see the original and delete the bad join etc.