Saving drawing as image (jpeg) - CNCzone.com-The Largest Machinist Community on the net!

Maguillacutty · #1 07-04-2010, 01:27 PM

meyellow fella's, been a min since i been on here seeking help

>>>>Wondering if there is a way after you draw up your part with surfcam can you save it some how as a jpeg pic image vs just printing it out on paper??>>>having a brain fart here and cant seem to figure it out.

hope your all having a good 4th of july

cadman · #2 07-04-2010, 03:01 PM

Ctrl + Prt Scr, open whatever application you use to view images, paste and save as jpeg, bitmap , etc...

Yefim.C · #3 01-17-2011, 07:24 AM

You can save as Plot-Flat DXF and than open in e-drowing and save as you wish

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Importing JPEG Image	patrick.jamo	CamWorks	9	03-26-2009 11:09 AM
Need Help!- How too, AutoCad drawing to BMP/JPEG	Holmes_ca	Autodesk Software (Autocad, Inventor etc)	5	02-17-2009 09:05 AM
image in drawing	sk96_me45	UG NX	1	02-11-2009 09:28 AM
Need Help!- converting imported part drawing to mold drawing	msomerville	BobCad-Cam	6	08-29-2008 06:56 AM
Saving rendered image	bogger44	BobCad-Cam	4	01-08-2007 07:45 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)