Time for ncPod forum yet? - CNCzone.com-The Largest Machinist Community on the net!

Greolt · #1 01-04-2007, 04:53 AM

I have a unit as a beta test. Art is writing a plugin for it.

I think this has potential to be a popular alternative controller.

Is it too early?

ger21 · #2 01-04-2007, 06:00 AM

I think you should ask questions in the Mach forum.

Greolt · #3 01-04-2007, 09:33 PM

Gerry although Art is working on a plugin it does come with its own SDK so not every topic of discussion will be Mach centred.

However going by the overwhelming response this post has solicited you're probably right.

In the next few months I'm sure it will happen but I guess not yet.

ger21 · #4 01-05-2007, 08:39 AM

Probably 95% (or more) of requested forums are removed within 2 months, because nobody posts in them. Give it a bit more time. You're the only one that I've seen post that actually has one. (other than Art)

Greolt · #5 01-05-2007, 02:58 PM

Yeah no worries Gerry. Will have to be patient

Greolt · #6 01-13-2007, 02:43 AM

For anyone interested there is now a new forum devoted to the ncPod over at Machsupport

http://www.machsupport.com/forum/index.php?board=45.0

Not much there yet but it should start to flow

And here is a link to an announcment about the plugin from Art (Mach3 author)

http://groups.yahoo.com/group/mach1m.../message/67189

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)