Results 1 to 3 of 3

Thread: This look like 500 watts to you?

  1. #1
    Registered Smertrios's Avatar
    Join Date
    Mar 2005
    Location
    USA
    Posts
    249
    Downloads
    0
    Uploads
    0

    This look like 500 watts to you?

    BIG STIRLING ENGINE RUNS ON ANY HEAT SOURCE - 850RPM 58cc - FULLY ASSEMBLED | eBay

    I watched the video of it spinning a flywheel and have doubt that its 500 watts of power =/ Near the bottom of the auction he claims that if given the right conditions it can produce 500 watts 24 hours a day. That said its the biggest of the relatively cheap and currently produced stirlings I've seen as most are just toys or so well made they cost a fortune.


  2. #2
    UUU
    UUU is offline
    Registered
    Join Date
    Apr 2010
    Location
    UK
    Posts
    289
    Downloads
    0
    Uploads
    0
    The whole machine look very much like the "Ky-Ko" fan which would have been powered from a kerosine burner with a wick, so not producing much power at all. Using gas to run it will give more output, but I doubt 500watts. google KyKo fan for more info.

    Looking at the crank arrangements, They look a little weedy for that much power.


  3. #3
    Registered
    Join Date
    Oct 2005
    Location
    Australia
    Posts
    2388
    Downloads
    0
    Uploads
    0
    Yeah the crank in the photos looks like a nasty design, and looks sloppy/worn too.

    I'm also doubting the "500W output" claim too, even with a 50% efficiency you need to be able to apply a 1000W heat differential to it, or maybe 1300W to 1500W of heat to the hot side? That sounds like a pretty severe flame, and that is only if you get 50% efficiency out of it which is unlikely as most flame sources will dump a heap of heat upwards (lost as convection in the hot exhaust air).


Similar Threads

  1. Problem- How to figure how much watts i need?
    By samsagaz in forum General Laser Engraving & Cutting Machine Discussion
    Replies: 1
    Last Post: 01-10-2012, 06:34 PM
  2. Amps vs Watts
    By Grebbo in forum General Electronics Discussion
    Replies: 2
    Last Post: 04-26-2008, 01:21 AM
  3. 40 watts not enough to cut 1/32" plywood?????
    By Mrebeiro70 in forum General Laser Engraving & Cutting Machine Discussion
    Replies: 10
    Last Post: 10-24-2007, 10:23 PM
  4. oz/in to lb/ft to watts
    By 307startup in forum Linear and Rotary Motion
    Replies: 11
    Last Post: 10-01-2007, 07:14 PM
  5. Converting oz/in to Watts
    By mikie in forum Servo Motors and Drives
    Replies: 8
    Last Post: 10-06-2005, 01:04 AM

Posting Permissions



About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.