| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
02-14-2010, 04:51 PM
| |||
| |||
Hello! I want to build a Tachus42 3 Axis Board stepper controller and as I am a total newby, I have one question! I want to use it with PM35L-48 printer motor (datasheet: http://www.eminebea.com/content/html...f/pm35l048.pdf) an if I have 24v volt power supply do I need ressitors from my stepper motor to power supply and how big must be current rating for power supply if I use three of these motors! And, can anyone tell - could I use these motors for small 8x8 inch cnc router table just for drilling precious holes in pcb's!???? Thank you!  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ready To Jump Chopper Board Tachus42/Phil | camcam | DeskCNC Controller Board | 1 | 06-25-2008 07:48 PM |
| Tachus42`s chopper board manual? | sierra | Controller Cards | 0 | 09-13-2007 05:35 AM |
| DIY Controller Board Power Supply | Fish4Fun | Open Source Controller Boards | 5 | 03-29-2007 03:43 PM |
| 30v dc power supply for the xylotex board? | ljoe1969 | General Electronics Discussion | 3 | 01-18-2006 08:50 PM |
| Any recommendations for a power supply for their 3 axis board? | ljoe1969 | Xylotex | 8 | 11-05-2003 03:39 PM |
| | |
Linear Mode
