under powering a stepper motor?

[opusinwood]

does any one know what would happen if a 1200oz/in motor rated for 3.4A was run on only 2A?
if the loss in power means the torque would drop to 600 or 700 oz/in that's still not a small amount of power, and then I could get the right drivers down the track a bit.

Matt
Http://opusinwood.com

[Crevice Reamer]

does any one know what would happen if a 1200oz/in motor rated for 3.4A was run on only 2A?
if the loss in power means the torque would drop to 600 or 700 oz/in that's still not a small amount of power, and then I could get the right drivers down the track a bit.

Matt
Http://opusinwood.com

Yep! That would drop it down to 706 in oz of torque, and it should work just fine.

Please give motor name, number and specs including inductance. I've been looking for a motor like this and it sounds like it might work with G540.

CR.