GS-D200S Controller - CNCzone.com-The Largest Machinist Community on the net!

Huddini · #1 11-24-2004, 07:30 AM

Is there someone out there that can help me how to connect three GS-D200S controllers to a printerport.
I really need some help with this (i am a newbie at this)

arvidb · #2 11-24-2004, 10:02 AM

What's a GS-D200S controller?

Arvid

ESjaavik · #3 11-24-2004, 01:01 PM

If I remember right (sometimes I do), it is a stepper controller molded into a cooling fin. Made by SGS-Thomson.

Huddini · #4 11-24-2004, 04:23 PM

Here is a link to this in PDF format

arvidb · #5 11-24-2004, 04:53 PM

Looks to me like you should connect Stepclk to a STEP pin, CW/CCW to the corresponding DIR pin. Connect Enable to a SPDT switch ("växlande brytare") so you can set it high (+5V) or low (GND). According to the data sheet it should be kept low while powering up and down, and high for normal operation.

Arvid

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Taig Mill, US Digital MS23, Controller???	marjamar	Taig Mills & Lathes	3	02-07-2007 10:16 AM
Open Source CNC Controller Specification	gregmary	DIY-CNC Router Table Machines	28	12-04-2005 10:58 PM
2nd generation DeskCNC controller now shipping	imserv	Product Announcements & Manufacturer News	13	10-01-2004 07:22 AM
Designing a controller card	arvidb	General Electronics Discussion	20	06-28-2004 11:33 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)