| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-19-2004, 07:19 AM
| |||
| |||
i have look at stepper3, http://www.clickautomation.com and some other i cant remember but they all want me to pay 300usd for postage only and that is for 4kg(8lbs) in total normaly that only cost around a 100bucks i need 4 stepping motor for a sieg X2 at least 150 oz/in and it will ned to work unipolar as bipolar drives har too costy working with this drive http://eftech.home.comcast.net/prod01.htm    |
|
#2
11-19-2004, 08:24 AM
| |||
| |||
| I got my steppers from ebay USA, shipping was about $50 for three I recall. As for servos, they can be had over here, again on ebay for cheap. As for drives, well it has to be Geckos, and again I shipped them direct from the USA for about $60 ish. Apart from that, if you buy from somewhere like farnell.com or rswww.com then you will pay waaaay too much. edit - oops, I read the title as UK, not DK, sorry!
__________________ (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management) |
|
#3
11-30-2004, 06:19 PM
| |||
| |||
| Try www.rsonline.dk |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What's the Specification to buy Step motor fro G210 ? | Calico | Gecko Drives | 6 | 04-14-2005 01:26 PM |
| Before buy the Step Motors. | samsagaz | Stepper Motors and Drives | 3 | 03-28-2005 06:50 PM |
| Ametek motors and step down ratio | dowling177 | Servo Motors and Drives | 5 | 03-01-2005 01:24 PM |
| Dirction / Step lines! | bigal | TurboCNC | 2 | 02-06-2005 02:51 PM |
| Choosing a step rate? | Rhodan | General Electronics Discussion | 4 | 04-26-2004 10:42 AM |
| | |
Linear Mode
