| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-12-2004, 11:47 PM
| |||
| |||
I'm looking for recommendations for stepper motors to use on a mill project. The mill is an older Bridgeport style knee mill with a 9"x36" table. It is going to see near daily use in my shop, but since it is an older mill, I don't want to dump a lot of money into it. I'm planning to use Gecko G201 or G210 drivers. I'll probably retain the acme lead screws, but if my budget allows, I may swap in lower grade ball screws. Does anyone have recommendations for stepper motors for this type of machine? I beleive most other knee mill conversions I've seen were using 800 - 1000 oz/in steppers. What would be best for use with the Gecko drivers? Who should I buy them from? Thanks in advance for your help!    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Attaching a Stepper | andy_ck87028 | DIY-CNC Router Table Machines | 4 | 12-24-2004 12:09 PM |
| Not good for a stepper motor? | FLUTE HEAD | Stepper Motors and Drives | 4 | 12-02-2004 12:31 AM |
| Stepper motor spec' source & question | Damachine | DIY-CNC Router Table Machines | 4 | 04-06-2004 02:01 PM |
| Fun with floppy stepper and driver | Konstantin | General Electronics Discussion | 5 | 03-08-2004 02:18 AM |
| disassembly of stepper motors | dhprc2 | General Electronics Discussion | 8 | 06-25-2003 08:09 PM |
| | |
Linear Mode
