Have Vexta Model A2042-9412; Need help with info - CNCzone.com-The Largest Machinist Community on the net!

DJ Morrow · #1 10-25-2004, 06:39 PM

I have a couple of Oriental Motor Co. Ltd. Vexta Model A2042-9412 steppers but can't find any info on them. They are 2 phase, 1.8deg / step, 1.8V DC, 4.5 Amp. The other number on them is QX8 10954.

Any help in finding out some information on these motors would be greatly appreciated. ( I've Googled myself to death trying to find something )

dertsap · #2 03-12-2006, 12:47 PM

did you ever get any info on those motors , i found a good deal on some but need some specs before i buy , thanks

WhiteTiger · #3 03-12-2006, 01:09 PM

This site has catalogs for the entire current Vexta lineup.

Discontinued models apparently aren't covered, and their catalogs leave a lot to be desired as far as organisation of info, but pretty much any spec you need is there for the ones they cover, if you have the patience to dig through for it bit by bit.

Tiger

dertsap · #4 03-12-2006, 07:15 PM

thanks dude

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need info on Vexta UD2115 drivers	jazz	General Electronics Discussion	0	09-30-2004 12:07 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)