| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Stepper Motors and Drives Discuss stepper motors, drivers and related topics here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
09-01-2008, 10:06 PM
| |||
| |||
Has anybody used the Nema 34, 665 oz. in. motors from Circuit Specialists ? I plan to drive them with my Hobby CNC Pro Control Board With a 42 VDC power supply. My concern is speed. I have not purchased them yet. These are the motor specs 6.0 V / phase 2.0 A / phase 3.0 ohms / phase 12 - Inductance / Phase 48 KG.CM. - Holding Torque These are my router Specs 48" - X 36" - Y 8" - Z 5/8 dia ball screws, 4.92 thds. / in. 1" dia Thompson shafts with linear ball bearings  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stepper Motor question | benn0280 | Stepper Motors and Drives | 6 | 01-16-2008 10:27 PM |
| Stepper motor question | alexis221 | Servo Motors and Drives | 3 | 10-05-2007 08:29 PM |
| Question about 6 amp stepper motor | Yellowbeard | Stepper Motors and Drives | 3 | 04-19-2005 08:51 PM |
| Stepper Motor Question | Dman | Servo Motors and Drives | 2 | 01-15-2005 09:55 PM |
| HELP!Question about stepper motor sz | dmoore3008 | DIY-CNC Router Table Machines | 2 | 05-02-2003 03:34 PM |
| | |
Linear Mode
