Info on a Step-Syn stepper - CNCzone.com-The Largest Machinist Community on the net!

BjBlaster · #1 07-28-2008, 09:10 AM

Hi guys,

Just wondering if anyone knows where I can find some more info on this stepper. I've got 3 of them ready to build my CNC machine, but don't know what voltage they are rated at.

http://king-prodaja.com/stranice/parts/5.jpg

Stepping motor Stepping motor
step-syn
0,75A
0,72 DEG
TYPE:103H7523-7052

Thanks

Bj

vksingh · #2 07-28-2008, 12:11 PM

Multiply your current with the winding resistance to get the voltage(End to end not center tap in case of unipolar six wire motor)

BjBlaster · #3 07-28-2008, 10:54 PM

Of course! I don't know why I didn't think of that

Anyway I will do that tonight. I was also hoping to find out what sort of torque it has etc... but they *look* they have enough grunt

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sonceboz step motor info - needed	dan20041	Stepper Motors and Drives	1	03-27-2007 08:33 PM
Step/Dir Stepper Control	kylecroft	Stepper Motors and Drives	2	02-10-2007 11:48 PM
Step motor & driver/controller kits info ?	Robert M	General Electronics Discussion	5	01-12-2007 05:40 AM
Step and direction info on M control	colin1544	AjaxCNC Control Products	1	05-31-2006 08:00 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)